MIPS Interface: Difference between revisions
m
no edit summary
mNo edit summary |
mNo edit summary |
||
Line 3:
Memory mapped registers are used to configure the MIPS Interface. The base address for these registers is <code>0x0430 0000</code>, also known as MI_BASE. However, because all memory accesses in the CPU are made using virtual addresses, the following addresses must be offset appropriately. For non-cached reads/writes, add <code>0xA000 0000</code> to the address. As an example, to directly write to the MI_MODE register, use address <code>0xA430 0000</code>.
Note that some of these registers have different behavior when writing to them, than when reading from them. When writing to a register that has Set and Clear bits, write a 1 on the desired bit. Writing 0's have no effect. Behavior is unknown when writing 1's to both Set and Clear bits in a pair at the same time.
= Registers =
| |||