Joybus Protocol: Difference between revisions
Added details regarding default state of data pin.
(Added N64 dancepad) |
(Added details regarding default state of data pin.) |
||
Line 6:
The controller or device will read this command and any extra data, and then respond appropriately. For example, when the console wishes to write to a Controller Pak, it will send 0x03, followed by a 2 byte address, 32 bytes of data, and then the stop bit.
The default state of the data pin is HIGH. If the connected device isn't in the process of sending a signal, it should not default to sending a HIGH signal (either set to LOW for reading, high-impedance, or disconnect). Wrongly setting the pin HIGH may disrupt the console and will prevent intermediate devices from reading any console signals.
== Command List ==
| |||