Joybus Protocol: Difference between revisions
Jump to navigation
Jump to search
Content added Content deleted
(Added details regarding default state of data pin.) |
(Added small note that unused bits during communication should not be constantly held LOW.) |
||
| Line 79: | Line 79: | ||
=== 0x01 - Controller State === |
=== 0x01 - Controller State === |
||
The response for this command is always the same length of 4 bytes (32 bits), but the data it represents will change depending on the type of controller device. A Controller Stop Bit is always included after the response bytes. |
The response for this command is always the same length of 4 bytes (32 bits), but the data it represents will change depending on the type of controller device. A Controller Stop Bit is always included after the response bytes. ''Note that in the following waveform diagrams, any LOW bit should send a Zero Bit as described in the [[#Operation|operation section]] above. Do not hold the line LOW constantly.'' |
||
==== Standard Controller ==== |
==== Standard Controller ==== |
||