Joybus Protocol: Difference between revisions
Added small note that unused bits during communication should not be constantly held LOW.
(Added details regarding default state of data pin.) |
(Added small note that unused bits during communication should not be constantly held LOW.) |
||
Line 79:
=== 0x01 - Controller State ===
The response for this command is always the same length of 4 bytes (32 bits), but the data it represents will change depending on the type of controller device. A Controller Stop Bit is always included after the response bytes. ''Note that in the following waveform diagrams, any LOW bit should send a Zero Bit as described in the [[#Operation|operation section]] above. Do not hold the line LOW constantly.''
==== Standard Controller ====
| |||